Electronics Worksheet: Final Test
Remember (Find the topic, use the idea): Find the topic: circuit, safety, formula, component, program, sensor or IoT. Use that lesson’s rule — complete loop, V = I × R, P = V × I, last command wins, true → if part. Safety answers are always: low voltage, dry hands, an adult, never the mains.
NameDateTime takenScore ___ / 40
- 1.Which of these is true of a series circuit? (a) many paths for current (b) one out, the rest glow (c) used in house wiring (d) one bulb out, all go out
- 2.💡 A battery lights 5 identical bulbs joined in series. One more identical bulb is added in series. How do the bulbs glow now? (a) the same (b) brighter (c) dimmer
- 3.🔘 A cell, a bulb and switches A, B, C and D are joined one after another in a single loop (series). A is ON, B is OFF, C is ON and D is ON. Does the bulb glow? (a) No (b) Yes
- 4.🔺 A current of 10 mA flows when 5 V is joined across a resistor. What is its resistance (in ohms)?
- 5.📏 Which unit measures energy used each second? (a) ohm (Ω) (b) volt (V) (c) ampere (A) (d) watt (W)
- 6.True or false: “each gets the full volts” is true of a parallel circuit. (a) True (b) False
- 7.🤖 What is a microcontroller? (a) a kind of bulb (b) a big desktop computer (c) a type of battery (d) a computer on one chip
- 8.🌈 Which band is read first on a resistor? (a) the widest gap (b) any band (c) the gold band (d) the one nearest an end
- 9.True or false: the voltmeter measures voltage. (a) True (b) False
- 10.✏️ In a circuit diagram, which part is drawn as a circle with M inside? (a) junction (b) voltmeter (c) motor (d) ammeter
- 11.⏱️ What does “wait 500 ms” do? (a) pauses for half a second (b) turns the LED off (c) waits 500 seconds (d) blinks 500 times
- 12.True or false: a microcontroller has a built-in keyboard. (a) True (b) False
- 13.🧮 Resistors of 10 Ω and 47 Ω are joined in series. What is the total resistance (in ohms)?
-
14.💡 An LED (with its resistor) is on pin 8. All pins start LOW. The program runs once:
set pin 7 LOW
set pin 8 HIGH
set pin 8 HIGH
set pin 7 LOW
set pin 7 LOW
Is the LED ON or OFF at the end? (a) OFF (b) ON - 15.⚡ A device works on 5 V and takes 3 A. What is its power (in watts)? =
- 16.True or false: on an LED, the shorter leg is the anode (+). (a) False (b) True
- 17.True or false: a wooden stick is an insulator. (a) True (b) False
- 18.Which job is done by the main chip? (a) connect sensors and LEDs (b) keeps the voltage steady (c) restarts the program (d) runs the program
- 19.🤖 In “if (temp > 30)”, what runs when temp is exactly 30? (a) neither part (b) both parts (c) the if part (d) the else part
- 20.Which of these is true of a parallel circuit? (a) bulbs share the voltage (b) one bulb out, all go out (c) one out, the rest glow (d) a single current path
- 21.⚡ What does an exhaust fan mainly change electricity into? (a) movement (b) heat (c) light (d) sound
- 22.🔍 Which is the odd one out? (a) a rubber eraser (b) a plastic straw (c) a plastic ruler (d) an iron nail
- 23.True or false: “a break stops every bulb” is true of a parallel circuit. (a) True (b) False
- 24.Which job is done by the reset button? (a) keeps the voltage steady (b) shows the board is on (c) runs the program (d) restarts the program
- 25.🔐 Is it a good or a risky habit to set a strong password? (a) risky habit (b) good habit
- 26.True or false: a school bell mainly makes movement. (a) False (b) True
- 27.💡 Old festival light strings went fully dark when one bulb failed. How were they joined? (a) by Wi-Fi (b) not joined (c) in series (d) in parallel
- 28.Which of these is the output? (a) a temperature reading (b) the fan starts (c) a button press (d) count button presses
- 29.⚡ What does a street light mainly change electricity into? (a) light (b) heat (c) movement (d) sound
- 30.🔘 A cell and a bulb are joined to two side-by-side paths: path 1 has switches A and B one after another, path 2 has switch C. A is ON, B is OFF and C is OFF. Does the bulb glow? (a) No (b) Yes
- 31.🔦 A circuit has a new cell, a good bulb and a switch that is ON. One wire has come loose from the cell. Does the bulb glow? (a) No (b) Yes
- 32.🔦 A circuit has a new cell, a good bulb and a switch that is ON. One wire has come loose from the cell. A gap in one wire is bridged by a graphite rod. Does the bulb glow? (a) No (b) Yes
- 33.⚙️ Which actuator would you use to move water to plants? (a) a servo motor (b) a display (c) a pump (d) an LED
- 34.🔌 Which metal is used for most electric wires at home? (a) glass (b) plastic (c) copper (d) rubber
-
35.🤖 if (distance < 15) { buzzer beeps } else { buzzer is silent }
The distance sensor reads 9 cm. What happens? (a) buzzer beeps (b) buzzer is silent - 36.True or false: the flow of charge is measured in volts (V). (a) False (b) True
- 37.📏 How many kilo-ohms (kΩ) is 9800 Ω? =
- 38.Which of these mainly gives out heat? (a) an LED lamp (b) a torch (c) a street light (d) a room heater
- 39.🔋 7 identical 1.2 V cells are joined in series (+ of one cell to − of the next). What is the total voltage (in volts)? =
- 40.Which of these is a conductor? (a) a paper strip (b) a rubber eraser (c) a safety pin (d) a plastic straw
Answer key
- one bulb out, all go out
- dimmer
- No
- 500
- watt (W)
- True
- a computer on one chip
- the one nearest an end
- True
- motor
- pauses for half a second
- False
- 57
- ON
- 15
- False
- True
- runs the program
- the else part
- one out, the rest glow
- movement
- an iron nail
- False
- restarts the program
- good habit
- False
- in series
- the fan starts
- light
- No
- No
- No
- a pump
- copper
- buzzer beeps
- False
- 9.8
- a room heater
- 8.4
- a safety pin
Free electronics lessons, practice and worksheets at talentjr.in/electronics-for-kids